ROLA Australia

Broadcast Equipment Manufacturers

All products supported and installed by our own

Broadcast & Microsoft Certified Systems Engineers

One of the first products to be manufactured by the early ROLA company circa 1960

see more at Peter O'Neil's web site http://clove.net.au/~poneill/index.html

Agents for BSI Software USA since 1995

Agents for Panaxis Productions since 1990

.

Audio delay software complete station liscense A$999

 

 

A windows based application that uses a standard PC with full duplex sound card and driver, to "time delay" audio for P.A., talkback radio or time zone delays. CD quality Delay times, from 7 seconds to weeks can be made (depending on PC specification and hard disk size). Software is intuitive and simple to install and use.

 

 

Stereo FM School Broadcaster with antenna A$899

 

(100 mw output - ) Ideal for short hop transmissions of up to 300mtrs. in low power stereo. The unit comes pre-built and tested complete with plugpack and 1/4 wave dipole  antenna ready to use. Frequency is  locked on 100mhz-FM on startup but is frequency agile with inbuilt PLL. The output can be attenuated on request to meet ACA LIPD standards, or used with leaky feeder systems for greater coverage.  Ideal for talking sign applications where cheap kit transmitters are found insufficient.

 

 

 

FM25 MONO EXCITER A$1599

FM25 EXCITER(BELOW) SHOWN WITH FM120 WATT LINEAR (ABOVE)

(20-25 WATTS) Ideal as a station exciter or as a local commuity station main transmitter the unit is a full FLL exciter using the Panaxis FMX1 board plus a Philips descrete component linear amplifier for an out put of 20-25 watts. The unit comes aligned on the frequency of your choice from 87.6 -108mhz. Also available the FM25B, in dual 25 watt output (50watts total) for A$1995  Stereo version add $499, Stereo version with audio AGC/Limiter/compressor/Processor add $699.

High power mono FM Broadcaster with antenna A$999

 

        

(1.04 watts ERP output - ) Uses the Panaxis exciter board assembled for Australian standards. Ideal for  transmissions of up to 10kms including LPON's.. The unit comes pre-built and tested complete with plugpack and full wave co-linear antenna ready to use. Frequency  agile with inbuilt PLL. The output can be attenuated on request to meet ACA LIPD standards, or used with leaky feeder systems for greater coverage.  Pro transmitter available in industrial (mounted on antenna boom) or rack mount version for $200 more.  These are also ideal for sporting arena's, Drive in theatres, movie theatre complexes, and public building installations, plus hearing impaired installations.

 

 

Low cost Stereo FM Broadcaster with MP3 capability A$149

This Transmitter can be used in a car and home. The transmitter complies with the ACA LIPD specifications and transmits up to 3 metres distance.

You can have the cleanest possible signal at low cost with dip switch selected frequencies of  87.3 / 87.7 / 87.9 / 88.1 / 88.3 / 88.5 / 88.7 / 106.7 / 106.9 / 107.1 / 107.3 / 107.5 / 107.7 / 107.9MHz 

New Fully Digital Broadcast Console  $5999

NEW LOWER PRICING

 

New for 2005 , Rola present the best value for money console for Radio anywhere. This fully digital console has lower cost than and outdated analogue one. Based on the Behringer DDX3216 engine, this console features a remote start module, for CD and DVD players, Minidisk players, tape and cart machines, turntables and more (if you still have  these). Full integration with BSI Simian MOHD automation system and more. All firmware is recoded, with instant recall of presets and technical settings secured behind a perspex panel to prevent announcers tweeking. Features like built in audio processing on main and auxiliary mix busses (you no longer need to purchase a rack of limiter/compressors to feed the transmitter chain), VU meters on every input and output channel. phantom feeds on mic channels, A and B buss outputs with separate mixes and minus 1 mix for satellite and regional networking. Built in digital phone hybrid , and in development 7 second delay firmware using the 4 x DSP's. Fully programmable and optimised for customers at order with up to 12 mic channels subgrouped and limited to optimise performance. All updates downloadable via serial port to PC or by memory card. Console can be reconfigured in seconds for Studio or O.B. use.  ALPS motorised faders are used throughout.  On site installation and training provided anywhere in Australia at a small cost. Delivery from time of order is only  3-4 weeks. The standard out of the box production use only version is also available for only $1499. The broadcast version is not the same as the DDX3216 it is extensively reprogrammed, and modified for broadcast use, plus also includes the remote switching module, multiplexer and monitoring rack (exclusive of studio power amplifier).

 

Studio monitor amplifiers

See our valvetron amplifiers in the separate valve amplifier section. Studio versions can be ordered with balanced inputs and cannon connectors on inputs and outputs for a small additional charge, even the popular 2A3 amplifier can be ordered as a studio monitor amplifier, the cost with rack mount case, and balanced input with all cannon sockets for connectors is priced at $899 for the  curve matching technology version.

 

 

 

Contact Information

 

Street address
P.O.
BOX 314 BLACKWOOD

SOUTH AUSTRALIA 5051

Electronic mail address
GTD@BETTANET.NET.AU
 
Office phone
61-08-82703175

FAX number
61-08-82703175

Back to Top
Copyright 1996-2005 ROLA AUSTRALIA